How to Install

How to install End Caps

Easy install, knock-in with a rubber mallet for a permanent fit*, no adhesive or weld required. A beveled edge on the underside of the cap makes for easy installation. Cap will fit firmly if installed correctly.

NCNC_Procedure_web

How to Install End Caps Video

*Correct permeant fitment of Nelsons CNC aluminium end caps is dependant on;
- Correctly prepared profile edges of extrusion.
- Correct end cap and profile dimensional synergy (refer to spec)
- End cap should be a tight fit with no movement after installation.
- End caps are intended for static (non-vibrational environment).

Correct fitment can be affected by ambient climatic change, care should be taken to access the location and safety of each item where such environmental conditions can occur.

For full terms https://www.nelsonscnc.com.au/terms-conditions/